Build fast electric RC cars ( Rc car kit )

After you have good experience with "Ready To Run" remote control car, then you are recommended to own fast electric rc car or normally called as "Remote control car pro kit". This type of remote control car is specially design for professional racer and the person who has good driving skill. Normally, standard package of this remote control car are contained components for main chassis only and you will need to assemble it components until complete as main chassis. To assemble your remote control car by your self is not easy, it's normally take about 4 to 5 hours to completed.

Advantage of having this pro kit are:
1. All selection of your remote car accessories are in your hand, you can choose from various type and manufacturer for your remote car.
2. You will know better the construction of your fast electric rc cars is. To understand it construction is important when doing maintenance or when you need to replace any parts in case of broken or wear.

To build it, you need a set of tools that will help you. Tools like Screw driver (small and medium size), Nut driver, Hobby knife, Side cutter, Scissor, Long nose pliers, Quick dry glue and vernier caliper.( to measure length of turnbuckle) are not included in the package. Others tools that needed to build fast electric remote control cars like various size of Allen wrench, Cross wrench, Turnbuckle wrench and thread lock nut are included in this package.( It may difference from each manufacturer of remote control cars )

Consideration before you start building your fast electric remote control cars.
1. Understand instruction guidelines.-Read and understand instructions carefully, follow the figure.
2. Perform your task on clean and tidy surface-The kit contain a small parts, probably your car parts loss is high on the scattered surface.
3. Cut off only the molded part which you would like to assemble to avoid the part mixed with other section of car parts-The kit component come with a few set of plastic molded parts, normally each set represent each section of remote control car and it comes with numbering on each part.
4. Remove access plastics or burr after cut off it from the part tree - This is needed when you assemble front and rear shock. Access plastic or burr will prevent the shock operating smoothly.
5. When you assemble ball end or ball cup on turnbuckle, make sure length from end to end is strictly follow the length which instructed in instruction manual - These part is assemble at critical section of your car.
6. Pay attention on unused parts and option parts - Package come along with used, unused and option parts.
7. After assembling process completed, make sure all screw and lock nut tightened enough but not over tightened.

After completed, you need another equipment like Transmitter, Servo, Receiver, Electric speed controller, Motor, Battery ( 7.2V 6 cells ), Battery charger, Rubber tires, Tire inserts and painted body shell. To make your car perfect you are advised to make an alignment on your car like Toe angle, Camber angle, Ride height and etc.


Technorati Profile